本帖最后由 孤鸿踏雪 于 2014-12-21 12:55 编辑
惭愧,对于金相检验,老孤只是略解皮毛而已。所以,对你咨询的问题,老孤无从回答,但在数年前在其它地方看到过有关““5%中间产物”这一概念的论述,现转载于此处,希望对你的检测工作有所帮助:
问: 5%ITP(中间转变产物)的深度如何掌握?按什么标准? 我有一个相关标准,但没有关于中间转变产物深度的明确规定,原文为: The visual estimated depth to 5% in termeditae products should be,at a minimum,50% of the effective case measurement on a gear pitheline or shaft diameter. For gear roots,the visual estimated depth to 5% intermediate products should be,at a minimum,25% of the effective case depth measurement of the gearroot. 应如何翻译?
答: ITP主要指贝氏体组织。5%的深度也是目测。其要求是:节圆处5%ITP的深度不能小于该处ECD(有效硬化层深度)测量值的25%。另一处的意思是表层IGO及非马深度不能大于0.025mm。
|